All in 1 Metal Coating

Rust-Rite All-in-1 Metal Coating is a decorative treatment for metal that treats rust and transforms any rough rusted metal surface into a smooth, tough, high gloss finish without the need for a primer or undercoat.

Rust Rite can be applied directly on new and rusted steel/metal, with no need of a primer or undercoat. Can also be applied on Galvanized, Stainless Steel and Aluminium surfaces.

ALL IN 1 METAL COATING

Direct to Rust
* No primer
* No undercoat
* No rust

Surface preparation: Remove all loose rust or flaking paint by wire brush or sand paper. Abrade and roughen all smooth surfaces with medium to coarse sand paper. Wash surface down with Rust Rite Wunda Clean and rinse with clean water. Ensure surfaces are dry and free from grease, oil, salts and chemicals.

By brush or roller: Stir paint well before and during use. Apply the 1st coat by lightly brushing and making sure the full surface and all edges are well sealed and covered. Ensure excess paint is removed and the coating is evened out. Apply a thick 2nd coat as soon as previous coat is dry (1-2 hrs). (Minimum film thickness of 120 microns is needed). When painting large flat areas it is recommended that you only use a roller or spray application to achieve a satisfactory finish.

By spray: Dilute Rust Rite with a mixing ratio of 10% with Rust Rite Thinners. Set spray equipment to 25/35 psi; adjust spray gun to full fan width, apply 3-4 coats, allowing a drying time of 1hr between coats. Shake spray gun during use to ensure an even colour and pattern. Ensure final coat is heavy enough to flow to a smooth, gloss finish avoiding runs and sags. No other thinners or solvent is recommended as this will affected the curing and drying time of the product.

Galvanized Surfaces: Prepare surface with Rust Rite Galv Prep then apply a single coat of Rust Rite Multi-Purpose Metal Primer.

Aluminium and Stainless Steel Surfaces: Lightly abrade, wash surface with Rust Rite Wunda Clean, prime with Rust Rite Multi-Purpose Metal Primer. Apply Rust Rite as top coat finish.

Coverage : 5sq/m per lt
Dry Time : Touch dry 1 hr
Re-coat : After 1-2 hrs
Rec Film Thickness : Min 100 mic
Clean up : Rust Rite Brush Cleaner & Thinners or Rust Rite Wunda Clean.
Thinners for Spraying : Rust Rite Brush Cleaner & Thinners
Pack size : 250ml, 500ml, 1lt, 2lt and 5lt

  • Wear a suitable dust mask and goggles when preparing surface.
  • Ensure adequate ventilation during application.
  • Avoid contact with skin and eyes.
  • In case of contact with eyes, rinse immediately with clean water and seek medical advice.
  • Wear suitable respiratory equipment when spraying.